Icom VE-PG3 Instruction Manual page 240

6
CONVERTER MODE SETTING SCREEN
9. [Port Settings] Menu (continued)
M Transceiver 1 (TRX1)/Transceiver 2 (TRX2)
*
**
*Appears only when "Enable" is selected in [Power Detection].
**Appears only when "Enable" is selected in [Serial Communication].
t Power Detection ............
y Power Detection Signal Logic
u Send and Receive Change
i Serial Communication ......
o TCP Port Number .........
!0 Communication Control ...
!1 Signal Level ..................
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
Select "Enable" to detect the power status (ON/OFF) of the radio.
Select the logic level to detect the power status (ON/OFF).
High : Outputs "High" while the power is ON.
Low : Outputs "Low" while the power is ON.
Select "Enable" to the commonly used line as the MIC input (A1 terminal)
and audio output (A3 terminal).
If your radio commonly uses one line as the MIC input and AF output, select
"Enable."
Select "Enable" to use the serial communication.
Enter the port number between 1024 and 65535.
Select the communication type.
Select the serial communication line signal level.
6-61
(Default: Disable)
(Default: High)
(Default: Disable)
(Default: Disable)
(Default: TRX1 5000,
TRX2 5001
EXT1 5002
EXT2 5003)
(Default: Full-Duplex)
(Default: ±5 V (RS-232C))