Icom VE-PG3 Instruction Manual page 264

6
CONVERTER MODE SETTING SCREEN
9. [Port Settings] Menu
M EXT Control Terminal (continued)
e Event OFF Time ............
r Control Input Detection ...
t Control Input Pull-up Setting
[Port Settings]–[EXT Input 1 (EXT1)/EXT Input 2 (EXT2)]
Select the delay time until the port B3/B4 terminal (General control input)) is
deactivated.
Range: [0.1], [0.3], [0.5], [1], [1.5], [2], [3](second)
Select the port input state of B3/B4 terminal (General control input). (Default:
Short circuit (LOW))
When the input port is pulled up:
• Short circuit (LOW)
• Open circuit (HIGH)
When the input port is NOT pulled up:
• Short circuit (LOW)
• Open circuit (HIGH)
Select "Enable" to internally pull up the B3/B4 terminal (General control
input).
6-85
: Active when the B3/B4 terminal (General control
input) is connected to the GND (LOW).
: Active when the B3/B4 terminal (General control
input) is open (HIGH).
: Active when no voltage is applied to the B3/B4
terminal (General control input).
: Active when a voltage is applied to the B3/B4 ter-
minal (General control input).
(Default: 1)
(Default: Enable)