Port Settings] Menu; M Transceiver Model; M Transceiver Connection "General Setting - Icom VE-PG3 Instruction Manual

6
CONVERTER MODE SETTING SCREEN

9. [Port Settings] Menu

M Transceiver Model

Select the radio to be connected to [TRX1]/[TRX2].
• The following explanation is an example of selecting "General Setting."
Transceiver Model ............
M Transceiver Connection
The setting screen when "General Setting" is selected in [Transceiver Model].
*
**
*Appears only when "Enable" is selected in [Power Detection].
**Appears only when "Enable" is selected in [Serial Communication].
q TX Volume Offset to Transceiver
.................................
w RX Volume Offset from Transceiver
.................................
e PTT Type .....................
r PTT Logic .....................
Select the radio to be connected to the [TRX1]/[TRX2] port.
• If your radio needs detailed setting, select "General Setting."
"General Setting"
Adjust the VE-PG3's transmitting audio level that is sent to the connected
transceiver between "15" and "–30" (dB).
Adjust the VE-PG3's audio level from the transceiver between "+26" to "–26" (dB).
Select the PTT circuit type.
• Single PTT: The speaker line and PTT input line are separated.
• Superimposed PTT: The PTT input line is superimposed on the MIC input
Select the PTT logic.
• High: PTT line becomes "High" when [PTT] is pushed. (Active High)
• Low: PTT line becomes "Low" when [PTT] is pushed. (Active Low)
6-60
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
(A1 terminal).
(Default: IC-F5060/F6060)
(Default: –22)
(Default: –24)
(Default: Single PTT)
(Default: Low)