Icom VE-PG3 Instruction Manual page 128

5
BRIDGE MODE SETTING SCREEN
8. [Port Settings] Menu (continued)
M Transceiver Connection
The setting screen when "General Setting" is selected in [Transceiver Model].
*
**
**
**
*Appears only when "Enable" is selected in [Power Detection].
**Appears only when "Enable" is selected in [Serial Communication].
q TX Volume Offset to the Transceiver
.................................
w RX Volume Offset from the Transceiver
.................................
e PTT Type .....................
r PTT Logic .....................
"General Setting"
Adjust the VE-PG3's transmitting audio level that is sent to the connected
transceiver between "–30" and "+15" (dB).
Adjust the VE-PG3's audio level from the transceiver between "+26" to "–26"
(dB).
Select the PTT circuit type.
• Single PTT: The microphone line and PTT input line are separated.
• Superimposed PTT: The PTT input line is superimposed on the MIC input
Select the PTT logic.
• High: PTT line becomes "High" when [PTT] is pushed. (Active High)
• Low: PTT line becomes "Low" when [PTT] is pushed. (Active Low)
5-66
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
(A1 terminal).
(Default: –22)
(Default: –24)
(Default: Single PTT)
(Default: Low)