Icom VE-PG3 Instruction Manual page 129

5
BRIDGE MODE SETTING SCREEN
8. [Port Settings] Menu
M Transceiver 1 (TRX1)/Transceiver 2 (TRX2)(continued)
*
**
**
**
*Appears only when "Enable" is selected in [Power Detection].
**Appears only when "Enable" is selected in [Serial Communication].
t SQL Type .....................
y SQL Logic .....................
u Power Detection ............
i Power Detection Signal Logic
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
Select the squelch signal type.
• Single SQL: The squelch signal is separately input.
• Superimposed SQL: The squelch signal is superimposed on the speaker
input line (A3 terminal).
Select the squelch detection type.
• High: The squelch line becomes "High" while receiving signal. (Active High)
• Low: The squelch line becomes "Low" while receiving signal. (Active Low)
Select "Enable" to detect the power status (ON/OFF) of the radio.
Select the logic to detect the power status (ON/OFF) of the radio.
• High: Becomes High when the radio's power is ON. (Active high)
• Low: Becomes Low when the radio's power is ON. (Active low)
5-67
"General Setting"
(Default: Single SQL)
(Default: High)
(Default: Disable)
(Default: High)