M Status Detection - Icom VE-PG3 Instruction Manual

6
CONVERTER MODE SETTING SCREEN
7. [V/RoIP] Menu (continued)

M Status Detection

Configure the details for telephone line.
q Dial Tone Detect ............
w Caller Connect ...............
e Caller Disconnect ............
r Callee Disconnect .........
t Line Cut ........................
Select "Enable" to detect the dial tone signal.
Select the detection type when the callee telephone's handset is picked up.
Select the detection type when the callee telephone is put on.
Select the detection type when the callee telephone is put on.
(In the case of the call was initiated by the callee.)
Select "Enable" to detect when the telephone line is disconnected.
6-25
[V/RoIP]–[LINE Settings]
(Default: Enable)
(Default: RBT Stop)
(Default: BT)
(Default: BT)
(Default: Enable)