Table Of Contents - Arctic Cat Y-12+ 2012 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983

Table of Contents

Removing Engine/ Transmission............................. 3-5
Top-Side Components............................................. 3-9
Removing Top-Side Components ........................... 3-9
Servicing Top-Side Components........................... 3-12
Installing Top-Side Components ........................... 3-19
Left-Side Components .......................................... 3-24
Removing Left-Side Components ......................... 3-24
Servicing Left-Side Components .......................... 3-26
Installing Left-Side Components ........................... 3-28
Right-Side Components ........................................ 3-31
Removing Right-Side Components....................... 3-31
Servicing Right-Side Components ........................ 3-34
Installing Right-Side Components......................... 3-35
Center Crankcase Components............................ 3-38
Separating Crankcase Halves............................... 3-38
Disassembling Crankcase Half ............................. 3-38
Servicing Center Crankcase Components............ 3-40
Assembling Crankcase Half .................................. 3-45
Joining Crankcase Halves..................................... 3-47
Installing Engine/Transmission.............................. 3-47
Removing Engine/
Transmission
Many service procedures can be performed without
removing the engine/transmission from the frame.
Closely observe the note introducing each sub-section for
this important information.
AT THIS POINT

If the technician's objective is to service Top-Side Com-
ponents, Left-Side Components, or Right-Side Compo-
nents, the engine/transmission does not have to be
removed from the frame.
AT THIS POINT

If the technician's objective is to service/replace
left-side cover oil seals, front output joint oil seal, rear
output joint oil seal, and/or the oil strainer (from
beneath the engine/transmission), the engine/transmis-
sion does not have to be removed from the frame.
Secure the ATV on a support stand to elevate the wheels.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
1. Remove the seat.
www.mymowerparts.com
Manual
Table of Contents
2. Remove the negative cable from the battery; then
remove the positive cable. Remove the battery and
the battery vent hose; then remove the battery.
CAUTION
Battery acid is harmful if it contacts eyes, skin, or cloth-
ing. Care must be taken whenever handling a battery.
3. Remove the radiator access cover, steering post
cover, and storage compartment cover assembly;
then remove the storage compartment box.
4. Remove the side panels.
5. Remove the instrument pod; then remove the front
rack and front body panel (see Section 8).
6. Drain the oil from beneath the engine/transmission;
then drain the coolant.
7. Remove the air filter (see Section 2).
8. Remove the vacuum hose and the fuel-pump-to-car-
buretor hose.
Section
Table of Contents
3
CF242A
733-441A
CD799A
3-5