Displaying And Maintaining Habp - 3Com Switch 4800G 24-Port Configuration Manual

738 C 51: HABP C
HAPTER
Configuring an HABP
Client
Displaying and
Maintaining HABP
ONFIGURATION
To do...
Enable HABP
Configure HABP to work in
server mode
Set the interval to send HABP
requests
Configure HABP to work in client mode on a device connected to the
administrative device. Since HABP is enabled and works in client mode by default,
this configuration task is optional.
Follow these steps to configure an HABP client:
To do...
Enter system view
Enable HABP
Configure HABP to work in
client mode
To do...
Display HABP configuration
information
Display HABP MAC address
table entries
Display HABP packet statistics display habp traffic
Use the command...
habp enable
habp server vlan vlan-id
habp timer interval
Use the command...
system-view
habp enable
undo habp server
Use the command...
display habp
display habp table
Remarks
Optional
Enabled by default
Required
HABP works in client mode by
default.
Optional
20 seconds by default
Remarks
-
Optional
Enabled by default
Optional
HABP works in client mode by
default.
Remarks
Available in any view
Available in any view
Available in any view