3Com Switch 4800G 24-Port Configuration Manual page 1066

1066 C 86: NQA C
HAPTER
HTTP Test Configuration
Example
ONFIGURATION
Network diagram
Figure 311 Network diagram for FTP
NQA Client
10 .1 .1.1/8
Switch A
Configuration procedure
# Create an FTP test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type ftp
[DeviceA-nqa-admin-test-ftp] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-ftp] source ip 10.1.1.1
[DeviceA-nqa-admin-test-ftp] operation put
[DeviceA-nqa-admin-test-ftp] username admin
[DeviceA-nqa-admin-test-ftp] password systemtest
[DeviceA-nqa-admin-test-ftp] filename config.txt
[DeviceA-nqa-admin-test-ftp] quit
# Enable the FTP test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an FTP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 173/173/173
Square-Sum of round trip time: 29929
Last succeeded probe time: 2007-03-14 13:28:48.5
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Network requirements
Use the HTTP function to test the connection with a specified HTTP server and the
time required to obtain data from the HTTP server.
FTP Server
10.2.2.2/8
IP network
Switch B
Receive response times: 1