3Com Switch 4800G 24-Port Configuration Manual page 528

528 C 40: T
HAPTER UNNELING
C
ONFIGURATION
Network diagram
Figure 159 Network diagram for an IPv6 manual tunnel
IPv4 netwok
Dual stack
Vlan -int100
192 .168.100.1/24
Switch A
Configuration procedure
Configuration on Switch A
■
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Configure a link aggregation group. Disable STP on the port before adding it
into the link aggregation group.
[SwitchA] link-aggregation group 1 mode manual
[SwitchA] link-aggregation group 1 service-type tunnel
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] stp disable
[SwitchA-GigabitEthernet1/0/1] port link-aggregation group 1
[SwitchA-GigabitEthernet1/0/1] quit
# Configure an IPv4 address for VLAN-interface 100.
[SwitchA] vlan 100
[SwitchA-vlan100] port GigabitEthernet 1/0/2
[SwitchA-vlan100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 192.168.100.1 255.255.255.0
[SwitchA-Vlan-interface100] quit
# Configure a manual IPv6 tunnel.
[SwitchA] interface tunnel 0
[SwitchA-Tunnel0] ipv6 address 3001::1/64
[SwitchA-Tunnel0] source vlan-interface 100
[SwitchA-Tunnel0] destination 192.168.50.1
[SwitchA-Tunnel0] tunnel-protocol ipv6-ipv4
# Configure the tunnel to reference link aggregation group 1 in tunnel interface
view.
[SwitchA-Tunnel0] aggregation-group 1
Configuration on Switch B
■
# Enable IPv6.
Dual stack
Vlan- int100
192.168.50.1/24
Switch B