Configuration Task List - 3Com Switch 4800G 24-Port Configuration Manual

Multicast Traceroute
Configuration Task
List
multicast information from Source travels from Switch A to Switch B and then to
Switch C.
The multicast traceroute utility is used to trace the path that a multicast stream
flows down from the multicast source to the last-hop router.
Concepts in multicast traceroute
1 Last-hop router: If a router has one of its interfaces connecting to the subnet the
given destination address is on, and if the router is able to forward multicast
streams from the given multicast source onto that subnet, that router is called
last-hop router.
2 First-hop router: the router that directly connects to the multicast source.
3 Querier: the router requesting the multicast traceroute.
Introduction to multicast traceroute packets
A multicast traceroute packet is a special IGMP packet, which differs from
common IGMP packets in that its IGMP Type field is set to 0x1F or 0x1E and that
its destination IP address is a unicast address. There are three types of multicast
traceroute packets:
Query, with the IGMP Type field set to 0x1F,
■
Request, with the IGMP Type field set to 0x1F, and
■
Response, with the IGMP Type field set to 0x1E.
■
Process of multicast traceroute
1 The querier sends a query to the last-hop router.
2 Upon receiving the query, the last-hop router turns the query packet into a request
packet by adding a response data block containing its interface addresses and
packet statistics to the end of the packet, and forwards the request packet via
unicast to the previous hop for the given multicast source and group.
3 From the last-hop router to the multicast source, each hop adds a response data
block to the end of the request packet and unicasts it to the previous hop.
4 When the first-hop router receives the request packet, it changes the packet type
to indicate a response packet, and then sends the completed packet via unicast to
the multicast traceroute querier.
Complete these tasks to configure multicast routing and forwarding:
Task
"Enabling IP Multicast Routing" on page 706
"Configuring Multicast Static Routes" on page 706
"Configuring a Multicast Route Match Rule" on page 707
"Configuring Multicast Load Splitting" on page 707
"Configuring a Multicast Forwarding Range" on page 707
"Configuring the Multicast Forwarding Table Size" on page 708
"Tracing a Multicast Path" on page 708

Configuration Task List

705
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional