3Com Switch 4800G 24-Port Configuration Manual page 872

872 C 67: Q S P
HAPTER O OLICY
n
Defining a Traffic
Behavior
C
ONFIGURATION
Table 69 The form of the match-criteria argument
Form Description
service-dot1p Specifies to match packets by 802.1p precedence of the service provider
8021p-list network. The 8021p-list argument is a list of CoS values. You can provide
up to eight space-separated CoS values for this argument. CoS is in the
range 0 to 7.
In a class configured with the operator and, the logical relationship
between the service VLAN IDs specified for the service-vlan-id keyword is
or.
service-vlan-id Specifies to match the packets of the VLANs of the operator's network.
vlan-id-list The vlan-id-list argument is a list of VLAN IDs, in the form of vlan-id to
vlan-id or multiple discontinuous VLAN IDs (separated by space). You can
specify up to eight VLAN IDs for this argument at a time. VLAN ID is in the
range of 1 to 4094.
source-mac Specifies to match the packets with a specified source MAC address.
mac-address
Suppose the logical relationship between classification rules is and. Note the
following when using the if-match command to define matching rules.
If multiple matching rules with the acl or acl ipv6 keyword specified are
■
defined in a class, the actual logical relationship between these rules is or when
the policy is applied.
If multiple matching rules with the customer-vlan-id or service-vlan-id
■
keyword specified are defined in a class, the actual logical relationship between
these rules is or.
Configuration example
1 Network requirements
Configure a class named test to match the packets with their IP precedence being
6.
2 Configuration procedure
# Enter system view.
<Sysname> system-view
# Create the class. (This operation leads you to class view.)
[Sysname] traffic classifier test
# Define the classification rule.
[Sysname-classifier-test] if-match ip-precedence 6
To define a traffic behavior, you need to create a traffic behavior and then
configure attributes for it in traffic behavior view.
Configuration procedure
Follow these steps to define a traffic behavior: