Tuning And Optimizing The Ripng Network - 3Com Switch 4800G 24-Port Configuration Manual

436 C 33: IP 6 RIP
HAPTER V
Configuring RIPng Route
Redistribution
Tuning and
Optimizing the RIPng
Network
Configuring RIPng
Timers
C
NG ONFIGURATION
To do...
Enter system view
Enter RIPng view
Configure a RIPng
priority
Follow these steps to configure RIPng route redistribution:
To do...
Enter system view
Enter RIPng view
Configure a default routing
metric for redistributed routes
Redistribute routes from
another routing protocol
This section describes how to tune and optimize the performance of the RIPng
network as well as applications under special network environments. Before
tuning and optimizing the RIPng network, complete the following tasks:
Configure a network layer address for each interface
■
Configure the basic RIPng functions
■
This section covers the following topics:
"Configuring RIPng Timers" on page 436
■
"Configuring Split Horizon and Poison Reverse" on page 437
■
"Configuring Zero Field Check on RIPng Packets" on page 438
■
"Configuring the Maximum Number of Equal Cost Routes for Load Balancing"
■
on page 438
You can adjust RIPng timers to optimize the performance of the RIPng network.
Follow these steps to configure RIPng timers:
To do...
Enter system view
Enter RIPng view
Use the command...
system-view
ripng [ process-id ]
preference [ route-policy
route-policy-name ] preference
Use the command...
system-view
ripng [ process-id ]
default cost cost
import-route protocol
[ process-id ] [ allow-ibgp ]
[ cost cost | route-policy
route-policy-name ] *
Use the command...
system-view
ripng [ process-id ]
Remarks
-
-
Optional
By default, the RIPng priority
is 100.
Remarks
--
--
Optional
By default, the default metric
of redistributed routes is 0.
Required
No route redistribution is
configured by default.
Remarks
-
-