3Com Switch 4800G 24-Port Configuration Manual page 1060

1060 C 86: NQA C
HAPTER
Configuring the DLSw
Test
ONFIGURATION
To do...
Configure the destination
port
Configure the size of probe
packets sent
Configure the string of fill
characters of a probe packet
sent
Specify a source port number
for a probe request in a test
operation
Configure the source IP
address of a probe request in
a test operation
Configure common optional
parameters
The DLSw test is used to test the response time of the DLSw device.
Configuration prerequisites
Enable the DLSw function on the peer device before DLSw test.
Configuring the DLSw test
Follow these steps to configure the DLSw test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as
DLSw and enter test type view
Configure the destination
address for a test operation
Use the command...
destination port
port-number
data-size size
data-fill string
source port port-number
source ip ip-address
Refer to "Configuring
Optional Parameters Common
to an NQA Test Group" on
page 1062
Use the command...
system-view
nqa entry admin-name
operation-tag
type dlsw
destination ip ip-address
Remarks
Required
By default, no destination port
number is configured for a
test operation.
The destination port number
must be the port number of
the listening service
configured on the NQA
server.
Optional
100 bytes by default.
Optional
The string of fill characters of
an ICMP probe packet is the
string corresponding with the
ASCII code 00 to 09 by
default.
Optional
By default, no source port
number is specified.
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Optional
Remarks
-
-
Required
Required
By default, no destination IP
address is configured for a
test operation.