Nqa Configuration Task List; Configuring The Nqa Server - 3Com Switch 4800G 24-Port Configuration Manual

1050 C 86: NQA C
HAPTER
NQA Test Operation
NQA Configuration
Task List
Configuring the NQA
Server
ONFIGURATION
server must be consistent with those on the client and must be different from
those of an existing listening service.
After you create a test group and enter the test group view, you can configure
related test parameters. Test parameters vary with the test type. For details, see the
configuration procedure below.
To perform an NQA test successfully, make the following configurations on the
NQA client:
1 Enable the NQA client;
2 Create a test group and configure test parameters according to the test type;
3 Perform the NQA test through the nqa schedule command.
4 View test results using the display or debug commands.
For TCP, UDP-jitter or UDP-echo tests, you need to configure the NQA server on
the peer device.
Complete these tasks to configure NQA.
Task
"Configuring the NQA Server" on page 1050
"Enabling the NQA Client" on page 1051
"Creating an NQA Test Group" on page 1051
"Configuring an NQA
Test Group" on page
1051
"Configuring the Collaboration Function" on page 1061
"Configuring Trap Delivery" on page 1061
"Configuring Optional Parameters Common to an NQA Test Group" on
page 1062
"Scheduling an NQA Test Group" on page 1063
Before performing TCP, UDP-echo or UDP-jitter tests, you need to configure the
NQA server on the peer device. The NQA server makes a response to the request
originated by the NQA client by listening to the specified destination address and
port number.
Follow these steps to configure the NQA server:
"Configuring the ICMP-echo Test" on page 1051 Use any of the
"Configuring the DHCP Test" on page 1053
"Configuring the FTP Test" on page 1053
"Configuring the HTTP Test" on page 1054
"Configuring the UDP-jitter Test" on page 1055
"Configuring the SNMP Test" on page 1057
"Configuring the TCP Test" on page 1058
"Configuring the UDP-echo Test" on page 1059
"Configuring the DLSw Test" on page 1060
Remarks
Required for TCP,
UDP-echo and
UDP-jitter tests
Optional
Required
approaches.
Optional
Optional
Optional
Required