3Com Switch 4800G 24-Port Configuration Manual page 694

694 C 48: MSDP C
HAPTER ONFIGURATION
Network diagram
Figure 205 Network diagram for anycast RP configuration
Switch A
Receiver 1
Vlan -int100
MSDP peers
Device Interface
Source 1 -
Source 2 -
Switch A Vlan-int300
Vlan-int103
Switch B Vlan-int100
Vlan-int103
Vlan-int101
Loop0
Loop10
Loop20
Configuration procedure
1 Configure the interface IP addresses and unicast routing protocol for each switch
Configure the IP address and subnet mask for each interface as per Figure 205.
Detailed configuration steps are omitted here.
Configure OSPF for interconnection between the switches. Ensure the
network-layer interoperation among the switches, and ensure the dynamic update
of routing information between the switches through a unicast routing protocol.
Detailed configuration steps are omitted here.
2 Enable IP multicast routing, and enable PIM-SM and IGMP
# Enable IP multicast routing on Switch B, enable PIM-SM on each interface, and
enable IGMP on the host-side interface VLAN-interface100.
<SwitchB> system-view
[SwitchB] multicast routing-enable
Source 1
Switch C
Vlan-int300
Switch B
Loop 10
PIM-SM
IP address
10.110.5.100/24
10.110.6.100/24
10.110.5.1/24
10.110.2.2/24
10.110.1.1/24
10.110.2.1/24
192.168.1.1/24
1.1.1.1/32
3.3.3.3/32
10.1.1.1/32
Source 2
Switch E
Vlan -int400
Switch D
Vlan -int200
Loop 10
Device Interface
Switch C Vlan-int101
Vlan-int102
Switch D Vlan-int200
Vlan-int104
Vlan-int102
Loop0
Loop10
Loop20
Switch E Vlan-int400
Vlan-int104
Receiver 2
IP address
192.168.1.2/24
192.168.2.2/24
10.110.3.1/24
10.110.4.1/24
192.168.2.1/24
2.2.2.2/32
4.4.4.4/32
10.1.1.1/32
10.110.6.1/24
10.110.4.2/24