Configuring The Member Devices - 3Com Switch 4800G 24-Port Configuration Manual

Configuring the
Member Devices
Enabling NDP Globally
and for Specific Ports
Enabling NTDP Globally
and for Specific Ports
Manually Collecting
NTDP Information
Enabling the Cluster
Function
Deleting a Member
Device from a Cluster
To do...
Enter cluster view
Add a candidate device to the
cluster
Remove a member device
from the cluster
Rebooting a member device
Communication between the management and member devices may be
interrupted due to some configuration errors. Through the remote control
function of member devices, you can control them remotely on the management
device. For example, you can reboot a member device that operates improperly
and specify to delete the booting configuration file when the member device
reboots, and thus achieve normal communication between the management and
member devices.
Follow these steps to reboot a member device:
To do...
Enter system view
Enter cluster view
Reboot a specified member
device
Refer to "Enabling NDP Globally and for Specific Ports" on page 912.
Refer to "Enabling NTDP Globally and for Specific Ports" on page 912.
Refer to "Manually Collecting NTDP Information" on page 913.
Refer to "Enabling the Cluster Function" on page 914.
To do...
Enter system view
Enter cluster view

Configuring the Member Devices

Use the command...
cluster
add-member
[ member-number ]
mac-address mac-address
[ password password ]
delete-member
member-number
[ to-black-list ]
Use the command...
system-view
cluster
reboot member
{ member-number |
mac-address mac-address }
[ eraseflash ]
Use the command...
system-view
cluster
917
Remarks
-
Optional
Required
Remarks
-
-
Required
Remarks
-
-