3Com Switch 4800G 24-Port Configuration Manual page 1095

[SwitchA-vlan2] quit
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 202.38.160.1 255.255.255.0
# Create a standby group 1 and set its virtual IP address to 202.38.160.111.
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Configure the priority of Switch A in standby group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
# Create a standby group 2 and set its virtual IP address to 202.38.160.112.
[SwitchA-Vlan-interface2] vrrp vrid 2 virtual-ip 202.38.160.112
2 Configure Switch B
# Configure VLAN 2.
<SwitchB> system-view
[SwitchB] vlan 2
[SwitchB-vlan2] port GigabitEthernet 1/0/5
[SwitchB-vlan2] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0
# Create a standby group 1 and set its virtual IP address to 202.38.160.111.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Create a standby group 2 and set its virtual IP address to 202.38.160.112.
[SwitchB-Vlan-interface2] vrrp vrid 2 virtual-ip 202.38.160.112
# Configure the priority of Switch B in standby group 2 to 110.
[SwitchB-Vlan-interface2] vrrp vrid 2 priority 110
3 Verify the configuration
You can use the display vrrp command to verify the configuration.
# Display detailed information of the standby group on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
IPv4-Based VRRP Configuration Examples
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: NONE
: 202.38.160.111
: 0000-5e00-0101
: 202.38.160.1
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0
1095