Introduction To Dhcp Client; Enabling The Dhcp Client On An Interface - 3Com Switch 4800G 24-Port Configuration Manual

59
Introduction to DHCP
Client
Enabling the DHCP
Client on an Interface
DHCP C
When configuring the DHCP client, go to these sections for information you are
interested in:
"Introduction to DHCP Client" on page 823
■
"Enabling the DHCP Client on an Interface" on page 823
■
"Displaying and Maintaining the DHCP Client" on page 824
■
"DHCP Client Configuration Example" on page 824
■
n
The DHCP client configuration is supported only on VLAN interfaces.
■
When multiple VLAN interfaces with the same MAC address use DHCP for IP
■
address acquisition via a relay agent, the DHCP server cannot be a Windows
2000 Server or Windows 2003 Server.
You are not recommended to enable both the DHCP client and the DHCP
■
Snooping on the same device. Otherwise, DHCP Snooping entries may fail to
be generated, or the DHCP client may fail to obtain an IP address.
With the DHCP client enabled on an interface, the interface will use DHCP to
obtain configuration parameters such as an IP address from the DHCP server.
For the Switch 4800G (operating as DHCP clients), the vendor and device
information contained in Option 60 of DHCP requests is not configurable; instead,
it is determined by the application program of the switches. Refer to Table 62 for
different information added in Option 60 based on device models.
Table 62 Description on the vendor and device information in Option 60
Device Model
3CRS48G-24-91
3CRS48G-24P-91
3CRS48G-48-91
3CRS48G-48P-91
3CRS48G-24S-91
Follow these steps to enable the DHCP client on an interface:
To do...
Enter system view
Enter interface view
C
LIENT ONFIGURATION
Use the command...
system-view
interface interface-type
interface-number
Vendor and device information
3Com Switch 4800G 24-Port
3Com Switch 4800G PWR 24-Port
3Com Switch 4800G 48-Port
3Com Switch 4800G PWR 48-Port
3Com Switch 4800G 24-Port SFP
Remarks
-
-