3Com Switch 4800G 24-Port Configuration Manual page 1185

n
Setting LLDP Operating
Mode
Configuring LLDPDU
TLVs
To make LLDP take effect, you need to enable it both globally and on the related
ports.
Follow these steps to set LLDP operating mode:
To do...
Enter system view
Set the initialization delay
period
Enter Enter Ethernet
Ethernet interface view
interface
Enter port
view/port
group view
group view
Set the LLDP operating mode
Follow these steps to configure LLDPDU TLVs:
To do...
Enter system view
Set the TTL multiplier
Enter Enter
Ethernet Ethernet
interface interface
view/port view
group view
Enter port
group view
Enable LLDP TLV sending
for specific types of LLDP
TLVs
Performing Basic LLDP Configuration
Use the command...
system-view
lldp timer reinit-delay value Optional
interface interface-type
interface-number
port-group { aggregation
agg-id | manual
port-group-name }
lldp admin-status { disable |
rx | tx | txrx }
Use the command...
system-view
lldp hold-multiplier value
interface interface-type
interface-number
port-group { aggregation
agg-id | manual
port-group-name }
lldp tlv-enable { basic-tlv { all
| port-description |
system-capability |
system-description |
system-name } | dot1-tlv { all
| port-vlan-id |
protocol-vlan-id [ vlan-id ] |
vlan-name [ vlan-id ] } |
dot3-tlv { all |
link-aggregation |
mac-physic | max-frame-size |
power } | med-tlv { all |
capability | location-id
{ civic-address device-type
country-code { ca-type
ca-value }&<1-10> |
elin-address Tel-Number } |
network-policy |
power-over-ethernet |
inventory } }
1185
Remarks
-
2 seconds by default.
Either of the two is required.
Configuration performed in
Ethernet interface view
applies to the current port
only; configuration performed
in port group view applies to
all the ports in the
corresponding port group.
Optional
TxRx by default.
Remarks
-
Optional
4 by default.
Either of the two is required.
Configuration performed in
Ethernet interface view applies
to the current port only;
configuration performed in
port group view applies to all
the ports in the corresponding
port group.
Optional
By default, all types of LLDP
TLVs except location
identification TLV are sent.