Configuring The Root Bridge - 3Com Switch 4800G 24-Port Configuration Manual

Configuring the Root
Bridge
Configuring an MST
Region
Task
"Configuring Leaf Nodes" on page
224
"Performing mCheck" on page 228
"Configuring Digest Snooping" on page 229
"Configuring No Agreement Check" on page 230
"Configuring Protection Functions" on page 233
n
In a network containing switches with both GVRP and MSTP enabled, GVRP
messages travel along the CIST. If you want to advertise a VLAN through GVRP, be
sure to map the VLAN to the CIST (MSTI 0) when configuring the VLAN-to-MSTI
mapping table. For detailed information of GVRP, refer to "GVRP Configuration"
on page 109.
Configuration procedure
Follow these steps to configure an MST region:
To do...
Enter system view
Enter MST region view
Configure the MST region
name
"Configuring an MST Region" on page
213
"Configuring the Work Mode of MSTP
Device" on page 216
"Configuring the Timeout Factor" on
page 219
"Configuring the Maximum Transmission
Rate of Ports" on page 220
"Configuring Ports as Edge Ports" on
page 221
"Configuring Path Costs of Ports" on
page 225
"Configuring Port Priority" on page 226
"Configuring Whether Ports Connect to
Point-to-Point Links" on page 221
"Configuring the Mode a Port Uses to
Recognize/Send MSTP Packets" on page
227
"Enabling the Output of Port State
Transition Information" on page 223
"Enabling the MSTP Feature" on page
224
Use the command...
system-view
stp region-configuration
region-name name

Configuring the Root Bridge

Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Required
Optional
Optional
Optional
Optional
Remarks
-
-
Optional
The MST region name is the
MAC address by default.
213