Table of Contents
Advertisement
Section 12 : Key Operator Mode
User Setting Mode [3]
Set two userset density levels and three USERSETs of magnification.
User Density Level 1 Setting [1]
Output copying samples from 16 density levels from Lighter to Normal or Normal to Darker,
then select the desired exposure and program it as USER 1.
The programmed copy density can be recalled by selecting USER 1 on the Basic Screen.
User Setting Mode Menu Screen
Procedure
1 Press [ HELP ] to display the Help Screen, then touch Key Operator Mode .
Enter a 4-digit key operator password, then touch OK to display the Key Operator
Mode Screen.
NOTE:
If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
2 Touch [3] User setting mode to display the User Setting Mode Menu Screen, then
touch [1] User density level 1 setting to display the User Density Level 1 Setting
Screen.
3 Place the original on the platen glass or in the RADF.
4 Touch Darker or Lighter to select the density level to be programmed.
5 Touch No.1 1~4 , No.2 5~8 , No.3 9~12 , No.4 13~16 , or Set density ## , then press
[ START ]. The density level sample sheet will be output.
6 Select the desired exposure from the sample sheet(s), then enter the density level
No. by using the touch screen keypad.
7 Touch OK to complete the setting and return to the User Setting Mode Menu Screen.
8 If no further changes are required, proceed to step 10.
9 If other user setting changes are required, touch desired key, from [1]~[3].
10 Touch PREVIOUS SCREEN to restore the Key Operator Mode Screen.
11 Touch PREVIOUS SCREEN to restore the Basic Screen to perform copying operations.
12 - 12
User Density Level 1 Setting Screen
Advertisement
Table of Contents
