Table of Contents
Advertisement
Section 8 : Special Original
Special Original (continued)
Z-Folded Original (continued)
2
Enter Print Quantity
Enter the desired print quantity.
To change the print quantity, press [ C (CLEAR QTY.) ] and enter the correct quantity.
3
Place Originals ... FACE UP in RADF
Position Z-folded original(s) in the document feeder.
NOTE:
Normal originals can also be loaded at the
same time.
HINTS:
• For details on positioning originals, see p.
4-4.
• For original and copy paper information,
see Section 4.
4
Start Copying
Press [ START ] to scan.
Memory indicator on the upper right of the Basic Screen
allows you to check the remaining memory.
Printing job starts in succession when the machine
becomes ready for output.
To suspend the scanning or printing job, press [ STOP ].
After copying is completed, all the scanned data will be
deleted automatically.
Press [ AUTO RESET ] to release the mode and reset the
machine.
CAUTION
When the finisher / trimmer unit / paper exit tray capacity is exceeded due to the print
quantity selected, remove the copied sets while the paper is exiting; otherwise mishandled
paper will occur.
8 - 16
INTERRUPT
PROOF COPY
STOP
CLEAR QTY.
START
TIM
POWER
ON /
Advertisement
Table of Contents
