Table of Contents
Advertisement
Section 7 : Output Modes
Tandem Mode (continued)
NOTE:
The tandem mode cannot be selected/continued in the cases shown below. The message "Please
wait/ Reserve is not available in Slave unit," "Slave unit error/ Please check slave unit," or "Please
check slave unit" will be displayed, as required.
• The tandem mode cannot be selected while the secondary copier is off state because of Auto
shut-off. Press [POWER SAVER ON/OFF] to release it.
• Selected tandem mode will be released automatically when the secondary copier activates
Auto shut-off. Press [POWER SAVER ON/OFF] to release it, then select the tandem mode
again to restart the procedure.
• When any trouble such as a paper misfeed or lack of paper occurs in the secondary copier, the
tandem mode will not be released but printing job cannot be performed on the secondary
copier. Take the appropriate troubleshooting measures to be ready for copying.
• Tandem printing job cannot be started if 5 reserve jobs (not in tandem mode) are entered on
the secondary copier. Wait until the reserve jobs are completed on the secondary copier.
• Selected tandem mode will be released automatically when the primary copier activates Auto
low power/Auto shut-off. Press [POWER SAVER ON/OFF] to release Auto shut-off if required,
then select the tandem mode again to restart the procedure.
3 Select the desired copying conditions on the primary copier.
NOTE:
Ordinary copying operation is still available on the secondary copier during the tandem mode
setting.
3
Enter Print Quantity
Enter print quantity on the primary copier, using the keypad.
When a print quantity amount of 100 is entered, the primary
and secondary copiers will each copy and output 50 sheets.
NOTES:
• Print quantity must be set for [3] or more copies to activate the
tandem mode.
• When the print quantity entered is an odd number, the primary
copier will copy and output one sheet/set more than the
secondary copier to accommodate the job.
CAUTION
When the Booklet tray / Trimmer unit tray capacity is exceeded, the finisher will cease
operating. To avoid such trouble, select an appropriate print quantity from the specifications
on p. 7-12.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the
copied sets as they exit; otherwise, mishandled paper will occur.
7 - 34
R
P
Y
COUNTER
CLEAR QTY.
INT
PRO
S
Advertisement
Table of Contents
