Table of Contents
Advertisement
Section 9 : Applications
Chapter (continued)
Procedure
1
Set Copying Conditions
1 Close the RADF securely, then press [AUTO RESET].
2 Touch APPLICATION on the Basic Screen to display the Application Selection Screen.
3 Touch Chapter . The Chapter Insertion Setting No. Screen will be displayed. The
1s2 mode is automatically selected.
Application Selection Screen
Chapter Insertion Setting No. Screen
4 Use the keypad on the control panel to enter the page number of each title page.
5 Touch SET .
To clear an incorrect entry, touch DELETE or press [C (CLEAR QTY.)]. The insertion
location will be deleted.
To enter the correct page number, touch SET and use keypad.
6 Repeat this for each title page number you want to appear on the right hand side.
When setting more than 15 locations, touch the arrow key to move to the next page.
Be sure to touch SET after each page number entry, up to a total of 30 entries.
OPTION:
Touch Booklet on the Chapter Insertion Setting No. Screen to use this function. To change the
selection of paper tray for copying title pages, touch Copy Insertion on the screen. In this case,
you can touch CHANGE OF THE INSERTION TRAY to change the currently selected paper tray
displayed on the screen.
NOTES:
• Entering "0" or the same page number twice will be ignored on the screen.
• Chapter insertions occur in sequence even if original page numbers are entered out of sequence.
• When a page number is larger than the total original page count, insertion occurs as the last
page of the document.
9 - 10
Advertisement
Table of Contents
