Table of Contents
Advertisement
Non-Sort Mode Using Primary (Main) Tray
The Non-sort mode simply means that the offset-stacker finisher modes are not selected.
Copies will be stacked upon exit without being offset by sorted sets.
With the Primary (main) tray initially selected on the Finisher Mode Selection Screen, FS-
108/FS-108BM outputs the printed sheets FACE DOWN in the proper order.
Basic Screen
Procedure
1 Close the RADF securely, then press [ AUTO RESET ].
2 Touch SORT on the Basic Screen to deselect it, if highlighted. The Non-sort icon will
appear in the output icon display.
3 Make copying selections, as required.
4 Enter the desired print quantity.
5 Position original(s) in the document feeder or on the platen glass.
6 Press [ START ] to begin copying in Non-sort mode.
Copies will exit face down, with the page heading toward the front of the copier.
NOTE:
Finisher primary (main) tray of FS-108/108BM Finisher gradually goes down while printed material
is output. DO NOT allow any object to interfere with the operation of the tray on the left side of the
finisher, as any interference may cause damage to the finisher.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the
copied sets while the paper is exiting; otherwise mishandled paper will occur.
Section 7 : Output Modes
3
2
1
3
2
1
7
7
Output
Output
Modes
Modes
Finisher
Specifications
Non-Sort
7 - 5
Advertisement
Table of Contents
