Table of Contents
Advertisement
Using the Multi-Sheet Bypass Tray (continued)
Load offset tabbed sheets so that the tab extensions are on the right at the rear (not front)
of the tray. The top sheet is designated face up as the first tab of the finished set. Subsequent
offset tab sheets follow in sequence. The tab extension width should be 12.5 mm or less.
When loading tabbed sheets in the Multi-sheet bypass tray, be sure to specify the paper
type as Tab paper on the Paper Type/Size Setting Screen; otherwise mishandled paper
may occur. See p. 6-20 to p. 6-22.
Rear
Front
Rear
Front
Example: 3 Tabbed sheets loaded in position for one finished set.
1st TAB
2nd TAB
Section 1
Introduction
3rd TAB
Printed
side
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
1st TABS
2nd TABS
Section 1
3rd TABS
Section 1
Introduction
Section 1
Introduction
Printed
Introduction
side
Section 6 : Basic Operations
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
ONE FINISHED SET
1st TAB
2nd TAB
Section 1
Section 1
Section 1
Introduction
Introduction
Introduction
3rd TAB
3 FINISHED SETS
6
Basic
Operation
Using Multi-sheet
Bypass Tray
6 - 45
Advertisement
Table of Contents
