Table of Contents
Advertisement
Punching Mode (continued)
4 Touch the desired punch position key on the screen to highlight it.
Punch Position Selection Screen
5 Touch OK on the Punch Position Selection Screen to restore the Finisher Mode
Selection Screen.
6 Touch OK on the Finisher Mode Selection Screen to complete the setting and return
to the Basic Screen.
The selection made in punching position will be reflected in the output icon display.
7 Select additional copying features, as required.
8 Enter the desired print quantity.
9 Position originals in the document feeder. When using Store mode, see p. 6-32 to p.
6-33.
10 Press [ START ].
NOTE:
Finisher primary (main) tray of FS-108/108BM Finisher gradually goes down while printed material
is output. DO NOT allow any object to interfere with the operation of the tray on the left side of the
finisher, as any interference may cause damage to the finisher.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the
copied sets while the paper is exiting; otherwise mishandled paper will occur.
Section 7 : Output Modes
7 - 17
7
Output
Modes
Punching
Advertisement
Table of Contents
