Table of Contents
Advertisement
How to Make a Basic Copy (continued)
2
Set Copying Conditions
1 Close the document feeder securely.
2 Press [ AUTO RESET ] to return to the initial status.
3 As required, set the copying conditions.
NOTE:
Be sure to complete the setting by resuming the Basic Screen. Without the Basic Screen displayed,
the machine will not start copying even though the [START] key is pressed.
Basic Copy Settings on Basic Screen
Copy mode
Copy density
Lens mode
Paper size
Reserve
Other Basic Copying Operations:
Store mode
Platen store mode
RADF store mode
Rotation
Check mode and Proof copy
Interrupt mode
Help mode
Using the Multi-sheet
bypass tray
Output Mode Operations:
Section 7 describes how to select output modes.
Special Original Selections:
Section 8 describes how to select special originals.
Application Selections:
Section 9 describes how to select Application functions.
Server Function:
Section 11 describes how to use Server functions.
NOTE:
If the Basic Screen displays ADJUSTMENT MODE in the message area, this means that the machine
was left in the service adjustment mode by a service centre. If this occurs, please contact your
service centre and request that the mode be turned off; otherwise copying may be adversely affected.
3
Enter Print Quantity
Enter the desired print quantity, using the control panel
keypad. The quantity entered will be displayed on the upper
right message area of the Basic Screen.
To change the print quantity, press [ C (CLEAR QTY.) ], then
enter the correct quantity.
Section 6 : Basic Operations
: see p. 6-5 ~ p. 6-9
: see p. 6-10 ~ p. 6-12
: see p. 6-13 ~ p. 6-18
: see p. 6-19 ~ p. 6-22
: see p. 6-23 ~ p. 6-28
: see p. 6-29 ~ p. 6-31
: see p. 6-32 ~ p. 6-33
: see p. 6-34 ~ p. 6-36
: see p. 6-37 ~ p. 6-40
: see p. 6-41 ~ p. 6-42
: see p. 6-43
: see p. 6-44 ~ p. 6-45
R
P
Y
INT
PRO
COUNTER
CLEAR QTY.
S
6 - 3
6
Basic
Operation
Basic Copy
Advertisement
Table of Contents
