Table of Contents
Advertisement
‡C REC PRG
Sets which preset record program number (NO.1 - NO.5) settings are used for record on day /
time set at same program line. Record program (NO.1 – NO.5) settings can be viewed by
pushing ENTER while number is selected at REC PRG parameter setting. (Push ENTER again
to return to this menu.) Note that accessing record program settings by this method is for
verification purposes only. To change record program settings see sec. '6-3. Record
Programming'.
‡D HDD
Shows percent of hard disk used to record setting at same program line for one week (if set to
CONTINUOUS record). If record time required exceeds available hard disk space, this
parameter will read OVER. When PRE ALARM and ONE SHOT recording are set in the TIMER
menu, no percentage is shown here because PRE ALARM and ONE SHOT recording are
dependent on alarm input.
u
To Program Timer:
a)
Move cursor to day parameter and select day setting.
b)
Move cursor to start time parameter and select time.
c)
Move cursor to stop time parameter and select time.
d)
Move cursor to REC PRG parameter and select program number.
e)
Repeat steps ‡@ – ‡C to make other required record programs.
f)
Move to SET and push ENTER to save and exit or move to EXIT and push ENTER to
cancel settings and exit.
u
Example Program:
(Continued following page.)
This use rate is a general percentage. Do not set
programs to fill 100% of disk space if you do not want to
run out of recording space. (Note that example programs
only use 70% of available hard disk space.)
[TIMER PROGRAM]
•@•@•@•@•@•@
TIME•@•@•@•@•@•@
1.
MON•`FRI
2.
MON
3.
EVERYDAY
4.
----------------
5.
----------------
6.
----------------
7.
----------------
8.
----------------
SET
Important
REC PRG
08:30•`17:30
NO.1
22:00•`09:00
NO.3
00:00•`00:00
NO.2
---:---:•`---:---
-------
---:---:•`---:---
-------
---:---:•`---:---
-------
---:---:•`---:---
-------
---:---:•`---:---
-------
EXIT
67
HDD
45%
15%
***
-----
-----
-----
-----
-----
Advertisement
Table of Contents
