Regarding Continuous Record Setting - Ganz CDR-16T Operation Manual

6-3-7. Regarding Continuous Record Setting

Continuous record means that record will be continuously performed from the start to stop
times set in the record program (see sec. '6-3-1. Continuous Record') using the record
parameters contained in the program. If you have set REC MODE to CONTINUOUS, you will
have 6 possible ways (6 settings) for record to change (or not change) upon alarm input. If
REC MODE is set to change upon alarm input, alarm record will be performed at 'real
time ', 60 fields / sec. for NTSC and 50 fields / sec. for PAL.
Alarm input
Record
CH1 - 16
Related setting (OFF, LAST CHANNEL, SWITCHOVER, ALL CHANNEL, PRIORITY or
SEQUENCE) is made at ALARM REC MODE. Alarm rec. mode sets record response upon
alarm input from one or more cameras.
•ž ALARM REC MODE Settings
u
Off
Recording continues according to the parameters set in the record program.
u
LAST CHANNEL
In this case, record will go to camera in alarm and record it until alarm reset or until another
alarm occurs.
Record
CH1 - 16
(Continued following page.)
Alarm record
(MODE setting
applied here)
If ALARM REC MODE is set to LAST CHANNEL,
SWITCHOVER, ALL CHANNEL or PRIORITY, you must
also make settings in TRIGGER sub menu (see sec.
'6-3-6. Regarding Trigger Setting').
If ALARM REC MODE is set to SEQUENCE, you must
also make settings in ALARM SEQ REC sub menu
shown following.
Alarm video (realtime)
CH1
only record
CH1
Alarm
input
Record
CH1 - 16
Alarm reset
Important
CH2
only record
CH2 Alarm 1
Alarm reset
input
63
Record
CH1 - 16
Alarm 2 reset