Table of Contents
Advertisement
6-4. Timer Program
This menu allows you to program up to 8 automatic start and stop times for record operations
based on time and day settings. TIMER then can be selected for REC PROGRAM in the
FUNCTION menu to apply these auto record settings. (See sec. '7. Function Menu Settings'.)
See sec. '5-1. Accessing MAIN Menu' for information on making menu selections.
‡@
Where
‡@ Priority placement
Priority order follows number order from position 1 (highest priority) to position 8 (lowest priority).
If more than one line is set to record within the same time period, the highest priority line will be
selected for recording. For example, if line 1 and line 3 are both set to record from 8:30 a.m. to 9
a.m., line 1 setting has higher priority and settings there will be used for record operation during
this time.
‡A Day
Sets which day(s) recording occurs. Selectable as MON, TUE, WED, THU, FRI, SAT, SUN,
MON – FRI, MON – SAT, or EVERYDAY.
‡B TIME
Sets start and stop time for when record should take place on day(s) set at same program line.
(Continued following page.)
[TIMER PROGRAM]
TIME
1.
MON
2.
EVERYDAY
3.
----------------
4.
----------------
5.
----------------
6.
----------------
7.
----------------
8.
----------------
‡A
If you set a stop time that is earlier than the start time,
record will continue into the next 24-hour period after the
start time.
For example, if 12:00 is start time and 10:00 is stop,
record will continue from noon one day until 10:00 a.m. of
the following day. In this case, record operations will be
performed for a total of 22 hours.
REC PRG
08:30•`17:30
NO.1
18:00•`22:00
NO.2
---:---:•`---:---
-------
---:---:•`---:---
-------
---:---:•`---:---
-------
---:---:•`---:---
-------
---:---:•`---:---
-------
---:---:•`---:---
-------
‡B
SET
EXIT
Important
66
HDD
11%
59%
-----
-----
-----
-----
-----
-----
‡C
‡D
Advertisement
Table of Contents
