Auto Backup / Program Relationship - Ganz CDR-16T Operation Manual

The maximum number of frames per second, when using the
auto-backup function, is 10 frames a second. If the number of
frames is set to over 10 frames a second the backup TIMER
cannot be used. Reduce the number of frames to less than 10
frames a second when setting up AUTO BACKUP.

9-6-2. Auto Backup / Program Relationship

When AUTO BACKUP is ON for any program (No. 1-5) alarm occurrence data only will be
backup recorded to DVD-RAM disk. However, how alarm CHs are recorded will depend on
the REC MODE setting in the record program. See examples following of how you can
expect record to occur.
Continuous Recording Mode
Ø Camera CHs will be recorded to configured HDDs regardless of alarm occurrence or not.
DVD-RAM disk will be recorded immediately after an alarm ends.
Ø Timelapse record to HDDs is performed while backup record of completed alarm in
progress (unless another alarm occurs).
Ø If alarm recording to hard disk begins while backup is still recording, backup record will stop,
then resume after alarm recording to HDD is finished.
(Continued following page.)
[RECORD]
PROGRAM-NO.1
REC MODE- CONTINUOUS
QUALITY-NORMAL
AUDIO-OFF
REC CHANNEL
NORM=16 FAST=0 SENS = 0
TIMELAPSE MODE 0.10SEC
UPDATE(NORM,SENS)= 1.60SEC
UPDATE(FAST)=***.**SEC
TOTAL REC TIME=30H52M
ALARM REC MODE- SEQUENCE
ALARM QUALITY – SUPER
TRIGGER
ALARM SEQ REC
SET
Note
119
BACKUP-AUTO
EXIT
This setting changes