Basic Operation; Power On / Off - Ganz CDR-16T Operation Manual

4. Basic Operation

Front panel operation buttons will be indicated in boxes
( ZOOM ) throughout this manual to make it easier to
distinguish between buttons and menus.
(button) vs. ZOOM (menu).

4-1. Power ON / OFF

Ø
CDR-16T will start uploading data from HDD memory when power is switched ON. Data load
completion takes approx. 30 sec. (see note below) and CONTROL group buttons will flash
until loading is completed.
Ø
Settings in operational memory are backed-up by an internal lithium battery having an approx.
life span of approx. 5 years (at 25° C). Battery will have to be replaced when the 'BACKUP
ERROR' message appears on your observation monitor. Consult your CBC supplier
regarding purchase of a replacement battery.
Ø
Do not turn power OFF while record operations are in process. If power is turned OFF during
record, final frames will not record properly and / or will not be saved to disk.
Ø
If a power failure occurs, POWER-ON-REC function will auto-restart record operations at the
point they were interrupted when power is again applied to the recorder. Record restart point
will also automatically record over final frames that were misrecorded at power loss.
Ø
Do not move unit with power ON. Moving unit with power ON may cause damage to the hard
disk and / or loss of drive contents.
Note
Data load completion time when 36GB internal HDD is
installed is approx. 30 sec. If your unit is a later internal
hard drive model and / or external drives configured, the
size and number of HDDs connected will determine how
long data load completion will take.
ZOOM
Note
17