Ganz CDR-16T Operation Manual page 13

‡D SCSI-A
Used to externally expand the number of hard drives used for record and playback. (SCSI
termination connector received with CDR-16T must be connected here if no external
drives are connected.) (See sec. '3-2-4. SCSI Connector' for pin assignments and other
details.)
‡E REMOTE
Used for control connection with remote control device. 37-pin D-sub connector (female). Note
connector lock screws are inch type. (See sec. '3-2-2. Remote Connector' for pin assignments
and other details.)
‡F ALARM
Used for external alarm input connection. 25-pin D-sub connector (female). Note connector lock
screws are inch type. (See sec. '3-2-3. Alarm Connector' for pin assignments and other details.)
‡G FAN
Used to air cool unit to prevent overheating. Do not block fan intake with other equipment or
objects. Front panel FAN ALM indicator will light red if fan operation fails.
‡H Ground Terminal
Used to ground unit to protect operators against static electricity and electrical shock.
‡I Fuse Holder
Should contain a 4.0A slow-blow fuse during operation to protect unit from over voltage
conditions. Note that fuse should only be changed or replaced by qualified personnel.
‡J AC IN
Used for connection to AC power source via supplied accessory cord.
7