Ganz CDR-16T Operation Manual page 128

‡F After closing tray, turn drive access panel thumbscrew clockwise to secure the drive.
‡G After a different disk has been installed, the message following will be displayed.
‡H Move cursor to CONTINUE, then push ENTER button to continue backup record from
the point where record stopped.
u
To Cancel Backup
‡@ Move cursor in DVD menu to STOP, then push ENTER button.
‡A Backup record operation will stop and remaining HDD data will not be recorded.
If backup is manually stopped, record will not restart at
next alarm occurrence. Backup record must be manually
reset to ON.
Note the following regarding AUTO-BACKUP:
Ø If loop record is ON, (See sec. '6-11. Other Settings'), record starts from
beginning of disk timeline and will begin to overwrite recorded content again
after maximum capacity has been reached.
Ø Auto Backup can only be preformed when record settings are set to 10 frames
per second.
Ø A warning message is displayed during backup recording if disk is not in DVD
drive or when backup record to DVD-RAM disk cannot be preformed.
SELECT CONTINUE OR STOP
Note
Important
122