Table of Contents
Advertisement
4-3-3. Date / Time Messages
The following error and operational messages may be displayed in place of current (or
recorded) date and time during use of your CDR-16T.
Displayed Message
NOW CHECKING HDD
POWER ON REC START
KEY PROTECT
TOO FAST RECORDING
MODE
NOW SEARCHING
TIMER PROGRAM
TIMER PROGRAM START
TIMER PROGRAM STOP
NO RECORDING CHANNEL
CANNOT FIND RECORD
HDD
CANNOT FIND PLAYBACK
HDD
ASSIGNING HDD USE
Description / Action
Data uploading from HDD memory at power ON. Data
load completion time determined by size and number of
drives configured. See sec. '4-1. Power ON / OFF'.
POWER-ON-REC function being performed. See sec.
'4-1. Power ON / OFF'.
This front panel button is locked out (disabled) from use.
See sec. '6-1. Protect'.
Record and playback cannot be performed at the same
time due to record interval. Record interval must be set
for more than 0.10 sec. See sec. '6-3-5. Regarding
Timelapse / Update Mode Setting'.
Other operations cannot be performed while searching
HDD. Perform other operations after search is complete.
See sec. '7-1. Date / Time Search' and sec. '7-2. Index
List Search'.
Programmed recording cannot start or stop when
settings are being made in TIMER PROGRAM. Finish
making settings and exit TIMER PROGRAM. See sec.
'6-4. Timer Program'.
Programmed recording starts.
Programmed recording stops.
Cameras are not connected at rear panel, or not
assigned for recording in menus. Check connections at
rear panel and record channel menu settings. See sec.
'6-3-4. Regarding Record Channel Setting'.
HDD operations have been limited. Verify HDD is
available for recording in HDD menu. See sec. '7-3.
HDD Information'.
No material has been recorded to HDD, or operations
have been limited. Verify HDD is available for playback
in HDD menu. See sec. '7-3. HDD Information'.
Other operations cannot be performed while HDD use is
being assigned. See sec. '6-10-1. Assign HDD Use'. Do
other operations after HDD assignment is complete.
23
Advertisement
Table of Contents
