Table of Contents
Advertisement
‡D Repeat step ‡A previous. Move USER BACKUP DVD cursor to STOP, then push
ENTER.
Start date/time and camera CH at monitor will be input.
START
•¨END
‡A
‡B
‡C
(•¦ Note that NTSC format shown above (M/D/Y). PAL time display is D/M/Y.)
‡E Size of data to be recorded from start to stop will now be displayed at backup size. Verify
free space for DVD-RAM is greater than BACKUP SIZE. If not you will have to either
change disks to finish recording ( see sec. '9-5-2. Changing Disks During User Backup'
following)or use a new disk
‡F After the start point and end point are set, move cursor mark to START, then push
ENTER to begin backup. When backup record begins, RECORD BACKUP DATA TO
DVD is displayed on monitor. At this time, all images on the hard disk between start point
(image A) to end point (image B) will be recorded to the DVD-RAM disk.
Hard disk
After backup is completed, USER BACKUP COMPLETE will be displayed on the
‡G
monitor. Move cursor mark to EXIT and push ENTER button to finish backup operation.
DVD drive will go to standby mode after about five
minutes of inactivity. If this occurs, it may take several
seconds for backup record to start when initiated.
[USER BACKUP DVD]
DATE
03 / 05 / 2001
03 / 06 / 2001
BACKUP SIZE-
FREE / CAPACITY-
START
CONTINUE
STOP
CLEAR
Start point
Image A
Important
116
TIME
10 : 10: 10 (MON)
10 : 10: 10 (TUE)
20.0M BYTE
4.4G BYTE / 4.4G BYTE
EXIT
Stop point
Image B
This part is recorded to DVD
CH
1
1
Advertisement
Table of Contents
