Sensor Operation; Sensor Menu - Ganz CDR-16T Operation Manual

8. Sensor Operation

8-1. Sensor Menu

You will need to make sensitivity and other settings before using the internally installed sensor
device. See sec. '5-1. Accessing MAIN Menu' for information on making menu selections.
‡@
‡A
‡B
Where:
‡@ MARKER DISPLAY
Sets if motion marker displayed on video (full screen view) or not.
LIVE
PB
‡A DAY TIME
Used to set start and stop times during which DAY settings made at [SENSOR] sub menu will be
applied. NIGHT settings applied at other times (stop – start).
‡B Camera and SENSE TERM
Shows current SENSE TERM (time period when motion sensor is ON) setting for each camera.
Channel reads NONE if no signal is input.
Also used to access [SENSOR] sub menu to make sensitivity and other settings. Select channel
number with arrow cursor and push ENTER to access sub menu. Push ENTER again to return
to this menu. See sec. '8-1-2. Sensitivity Settings'.
MARKER DISPLAY – ON
DAY TIME – 09:00 •` 17:00
CH1 - -DAY/NIGHT
CH3 - -DAY/NIGHT
CH5 - -DAY/NIGHT
CH7 - -DAY/NIGHT
CH9 - -DAY/NIGHT
CH11 - -DAY/NIGHT
CH13 - -DAY/NIGHT
CH15 - -DAY/NIGHT
OFF Motion marker not displayed on camera video.
ON Motion marker displayed on camera video.
OFF Motion marker not displayed during playback.
ON Motion marker displayed during playback.
If start and stop times are the same (09:00 – 09:00), it will
always be 'daytime' and only day settings can be applied.
[SENSOR]
LIVE PB
ON
CH2
CH4
CH6
CH8
CH10 - -DAY/NIGHT
CH12 - -DAY/NIGHT
CH14 - -DAY/NIGHT
CH16 - -DAY/NIGHT
SET EXIT
Important
101
- -DAY/NIGHT
- -DAY/NIGHT
- -DAY/NIGHT
- -DAY/NIGHT