Continuous Record - Ganz CDR-16T Operation Manual

6-3-1. Continuous Record

When you select CONTINUOUS as the REC MODE setting in the RECORD menu, you can
record continuously and automatically change to real time recording (NTSC: 60 fields / sec.,
PAL: 50 fields / sec.) when an alarm is input. Settings displayed in this menu should be
similar to those shown below. See sec. '5-1. Accessing MAIN Menu' for information on
making menu selections.
‡@
‡A
‡B
‡C
‡D
‡E
‡F
‡G
‡H
‡I
‡J
‡K
Where:
‡C AUDIO record
OFF
MONO
STEREO
‡D REC CHANNEL
Accesses sub menu that allows user to set update frequency (NORM, FAST or SENS) for
each camera channel or whether the camera channel skipped (not recorded) when record
program is applied. See sec. '6-3-4. Regarding Record Channel Setting'.
(Continued following page.)
If CONTINUOUS mode is selected, QUALITY setting can
be independently made for alarm record (ALARM
QUALITY) and non-alarm record (QUALITY) operation.
PROGRAM – NO.1
REC MODE – CONTINUOUS
QUALITY – NORMAL
AUDIO – OFF
REC CHANNEL
NORM = 4 FAST = 2 SENS = 0
TIMELAPSE MODE 0.10SEC
UPDATE (NORM, SENS) = 0.80SEC
UPDATE (FAST) = 0.40SEC
TOTAL REC TIME= 30H52M
ALARM REC MODE – SEQUENCE
ALARM QUALITY – SUPER
TRIGGER
ALARM SEQ REC
Settings ‡@ – ‡B are not explained here as they are the
same For all recording modes. Refer to sec. '6-3. Record
Programming' previous.
No audio input or no audio record performed.
Mono audio input and recorded.
Stereo audio input and recorded.
Note
[RECORD]
SET EXIT
Important
49