Scanning Only The Specified Memory Channels; Setting Memories To Skip - Yaesu FTM-100DR Operating Manual

Scanning only the specified memory channels

1
Select the band to be scanned, and then switch to memory mode.
2
Press and hold
The Setup menu appears.
3
Rotate the DIAL to select [3 MEMORY], then press
The menu list appears.
4
Rotate the DIAL to select [2 MEMORY SCAN TYPE], then press
The menu list appears.
5
Rotate the DIAL to select [2 SELECT MEMORY].
6
Press and hold
The display is returned to the previously viewed screen.
7
Press and hold [UP] or [DWN] on the microphone for over one second.
Scanning of the specified memory channels begins.
Tips • Pressing [UP] scans in the memory channel numbers in the upward direction, whereas
pressing [DWN] scans the memory channel numbers in the downward direction.
• To cancel scanning, press [PTT] on the microphone (this does not put the transceiver into
transmit mode).

Setting memories to skip

Memory channels which you do not want to receive can be skipped during scanning.
1
Press and hold
The MEMORY WRITE screen appears.
2
Press , (
3
Rotate the DIAL to select the desired memory
channel.
for over one second.
for over one second.
for over one second.
appears on the left side).
Searching for signals
.
.
67