Setting The Frequency Offset For Repeater Shift Rpt Shift Freq Function; Disabling Receiver While No Signal Is Received Receiver Battery Save Function; Changing The Frequency Step Manually; Setting Clock Time - Yaesu FT2DR Operating Instructions Manual

Setting the frequency offset for Repeater Shift
RPT SHIFT FREQ Function
Set the repeater shift offset frequency.
1
Rotate the DIAL, then touch [16 RPT SHIFT FREQ].
2
Rotate the DIAL to select the desired shift offset.
The offset frequency can be set in steps of 0.05 MHz between 0.000 MHz and 150.000
MHz.
Remark The default setting differs depending frequency
Disabling Receiver While No Signal Is Received
Receiver Battery Save Function
Sets the Receive OFF Battery save interval (sleep ratio) to reduce power consumption.
1
Rotate the DIAL, then touch [17 SAVE RX].
2
Rotate the DIAL to select the desired setting (the time interval for disabling the receiver
operation).
0.2 sec (1:1) to 1.0 sec (1:5)
to 1.0 sec (1:5) to 10 sec (1:50)
to 1.0 sec (1:50) to 60 sec (1:300 sec)
OFF
Selecting OFF disables this function.
Remark
The default setting: 0.2 sec (1:1)

Changing the Frequency Step Manually

Rotate the DIAL to select [18 STEP] to set each frequency step, when the Dial Knob is
turned manually.
For details, see "Setting the Frequency Step" on page 47.

Setting Clock Time

Rotate the DIAL to select [19 DATE & TIME ADJ] to set the built-in clock time.
For details, see "Setting Clock Time" on page 43.
Set Mode: CONFIG Menu Operations
In steps of 0.1 second
In steps of 0.5 second
In steps of 5 second
151