Using Web Interface to Manage the Access Point
Managing the Device
•
GPS Altitude: Enter the value in the format required by your network management system.
•
Country Code: The country in which the AP will be used.
NOTE: You must reboot the AP in order for country selection to take effect.
NOTE: Country selection is available only on APs with model numbers ending in -WD. If country selection is available,
however, it must be set before any interface parameters can be configured.
CAUTION: Romania does not support in the 20 and 40 MHz band in 11na mode. For UK 11na does not support 40 MHz
band. The table below specifies the details:
Country allow 11g
Romania Yes
UK
Yes
Click OK.
Figure 6-36 System Information Page
System Inventory Management Component
This page provides information about the device hardware, firmware, and software version information. For more
information, See
Using CLI to Manage the Access
allow11a turbo
allow11gturbo allow11ng20 allow11ng40 allow11na20 allowna40
No
Yes
No
Yes
Yes
Yes
Point.
AP-8000 User Guide
Yes
No
Yes
Yes
No
No
82