System Parameters; Inventory Management Information; Network Parameters; Ip Configuration Parameters - Proxim ORINOCO AP-600B User Manual

System Parameters

Name
System
Name
Location
Contact Name
Contact E-mail
Contact Phone
FLASH Backup Interval
Flash Update
System OID
Descriptor
Up Time
Emergency Restore to defaults

Inventory Management Information

Name
System Inventory Management
Component Table
Component Interface Table
1 2 7 ( 1 2 7 (
1 2 7 ( 1 2 7 (
The inventory management commands display advanced information about the AP-600's installed
components. You may be asked to report this information to a technical representative if you contact customer
support.

Network Parameters

IP Configuration Parameters

Name
Network
IP Configuration
IP Address
IP Mask
Default Router IP Address
Default TTL
Address Type
1 2 7 ( 1 2 7 ( 1 2 7 ( 1 2 7 (
The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask
(ipmask) or Default Gateway IP Address (ipgw) values can be entered.
Type Values
Group N/A
DisplayString User Defined
DisplayString User Defined
DisplayString User Defined
DisplayString User Defined
DisplayString User Defined
max 254 characters
Integer 0 - 65535 seconds
0
1
DisplayString N/A
DisplayString System Name, flash
version, S/N, bootloader
version
Integer dd:hh:mm:ss
dd – days
hh – hours
mm – minutes
ss – seconds
Resets all parameters to
default factory values
Type Values
Subgroup N/A
Subgroup N/A
Subgroup N/A
Type Values
Group N/A
Group N/A
IpAddress User Defined
IpAddress User Defined
IpAddress User Defined
Integer User Defined (seconds)
64 (default)
Integer static
dynamic (default)
Command Line Interface (CLI)
Access CLI Parameter
R system
RW sysname
RW sysloc
RW sysctname
RW sysctemail
RW sysctphone
RW sysflashbckint
RW sysflashupdate
R sysoid
R sysdescr
R sysuptime
RW sysresettodefaults
Note: You must enter the
following command twice to
reset to defaults:
set sysresettodefaults 1
Access CLI Parameter
R sysinvmgmt
R sysinvmgmtcmptbl
R sysinvmgmtcmpiftbl
Access CLI Parameter
R network
R ip (Note: The network and
ip parameters display the
same information)
RW ipaddr
RW ipmask
RW ipgw
RW ipttl
RW ipaddrtype
113