Inventory Management Information; Network Parameters; Location Parameters - Proxim Orinoco AP-2500 User Manual

Using the Command Line Interface
SSL Version DisplayString Size(1..32)
Block ICMP from Integer
Pending
Subscriber

Inventory Management Information

Name
System Inventory Management
Component Table
Component Interface Table
NOTE: The inventory management commands display advanced information about the AP's installed components.
You may be asked to report this information to a technical representative if you contact customer support.

Network Parameters

Name
Network
IP Configuration
IP Address
IP Mask
Default Router IP Address
Default TTL
Address Type
NOTE: The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask
(ipsubmask) or Default Gateway IP Address (ipgw) values can be entered.

Location Parameters

You can also configure the AP's basic IP settings using the following Location parameters:
Name
Location
Network IP Address
Network Subnet
Mask
Gateway IP Address
N/A
disable (0)
enable (1)
Type Values
Subgroup N/A
Subgroup N/A
Subgroup N/A
Type Values
Group N/A
Group N/A
IpAddress User Defined
IpAddress User Defined
IpAddress User Defined
Integer User Defined
64 (default)
Integer static
(default)
Type Values
Group N/A
IpAddress User Defined
DisplayString User Defined
Size(0..238)
IpAddress User Defined
R sslVersion
RW blockICMPFromPending
Access CLI Parameter
R sysinvmgmt
R sysinvmgmtcmptbl
R sysinvmgmtcmpiftbl
Access CLI Parameter
R network
R ip (Note: The network and
ip parameters display the
same information)
RW ipaddr
RW ipmask
RW ipgw
RW ipttl
RW ipaddrtype
Access CLI Parameter
R location
RW/Reboot locationNetworkIp
RW/Reboot locationNetmask
RW/Reboot locationGateway
222