Proxim ORiNOCO AP-8000 User Manual page 125

Using CLI to Manage the Access Point
Configuring the Device Using CLI Commands
profile-name: WPA-WPA2
authentication-mode: dot1x
wep-key-index: 0
wepkey: ******
wepkeylength: wep64
encryption-type: wpa-wpa2aes-tkip
psk: ******
rekeyinterval: 900
entry-status: active
}
Filtering Configuration
The Access Point's Packet Filtering features help control the amount of traffic exchanged between the wired and wireless
networks. There are four sub-tabs under the Filtering heading.
Advanced Filtering Configuration
The following protocols are listed in the Advanced Filter Table
• Deny IPX RIP
• Deny IPX SAP
• Deny IPX LSP
• Deny IP Broadcasts
• Deny IP Multicasts
The AP can filter these protocols in the wireless-to-Ethernet direction, the Ethernet-to-wireless direction, or in both
directions.
You can configure the following advanced filtering options:
# configure
(config)# dev-configure
(config-dev<config>-filter-advanced)# index 1 protocol-name Deny IPX RIP
(config-dev<config>-filter-advanced)# index 1 direction both
(config-dev<config>-filter-advanced)# index 1 row-status notInSevice
Show command for Advanced Filtering Configuration
Device-Name # show configure filtering advanced-filter-table
// RUNNING-CONFIGURATION //
// Advanced Filter Table //
index 1 {
protocol-name: Deny IPX RIP
direction: both
row-status: notInService
}
index 2 {
protocol-name: Deny IPX SAP
direction: both
row-status: notInService
}
index 3 {
protocol-name: Deny IPX LSP
direction: both
row-status: notInService
}
index 4 {
AP-8000 User Guide
125