Proxim ORiNOCO AP-8000 User Manual page 71

Using Web Interface to Manage the Access Point
Configuring the Device
Figure 6-22 QoS Profile Page
1. Enter the QoS Profile Name.
2. Enter the Policy Name that you have defined in the QoS Policy Table.
3. Enter the EDCA Profile Name that you have defined in the EDCA Table.
4. Select the QoS NO ACK Status for the QoS Profile table.
5. Click Ok.
QoS Policy
Perform the following procedure to enable QoS and QoS Policies:
Figure 6-23 QoS Policy page
1. Navigate to Configuration > QoS > Policy
2. Enter the Policy Name. By default, the policy name is provided.
3. By default the Policy Type is displayed. Following Policy Types are available:
• Inbound Layer 2: inbound traffic direction, Layer 2 traffic type
• Outbound Layer 2: Outbound traffic direction, Layer 2 traffic type
• Inbound Layer 3: Inbound traffic direction, Layer 3 traffic type
• Outbound Layer 3: Outbound traffic direction, Layer 3 traffic type
4. Enter the Priority Mapping. For layer 2 policies, an index from the DOT1D to DOT1P mapping table should be
specified. For layer 3 policies, an index from the DOT1D to IP DSCP mapping table should be specified.
AP-8000 User Guide
71