Using CLI to Manage the Access Point
Managing the Device Using CLI Commands
(config-mgmt-sys-sysmgmt)#exit
(config-mgmt-sys)#exit
(config-mgmt)#exit
(config)#exit
# show management system management
Country Code Configuration
(config-mgmt-sys)# ?
Possible completions:
country-code
exit
management
system-information
(config-mgmt-sys)# country-code BE
Device-Name# show management system country-code
// RUNNING-CONFIGURATION //
// System Configuration //
system {
country-code: BE
}
Inventory management
All are read-only commands. So there is no configuration for inventory commands.
Device-Name# show management system inventory-mgmt component-table
// RUNNING-CONFIGURATION //
// System Inventory Management Table //
index 1 {
serial-number: BUILD-360
name: Wireless Card 1 -NIC (0x60)
component-id: 2300
component-variant: 1
release-version: 7
major-version: 0
minor-version: 0
}
index 2 {
serial-number: BUILD-360
name: Wireless Card 2 -NIC (0x60)
component-id: 2300
component-variant: 1
release-version: 7
major-version: 0
minor-version: 0
}
index 3 {
serial-number: 202181
name: AP Software Image
component-id: 2100
component-variant: 1
release-version: 1
System Country Code
Exit from configure mode
System Management
System Information
AP-8000 User Guide
136