Proxim ORiNOCO AP-8000 User Manual page 121

Using CLI to Manage the Access Point
Configuring the Device Using CLI Commands
priority-mapping: 1
marking-status: enable
entry-status: notInService
}
MAC ACL Configuration
MAC ACL is to build a list of authorized wireless clients that can register at the unit and access the network. MAC ACL is
supported on the wireless interface and should be entered in the list
Profile Table Configuration
Perform the following to configure the Profile table entries.
NOTE: AP-8000 supports only one profile.
(config)# dev-configure
(config-dev<config>)# security
(config-dev<config>-security)# mac-acl
(config-dev<config>-security-mac)# profile-tbl
(config-dev<config>-security-mac-profile<tbl>)# index 1 status active
(config-dev<config>-security-mac-profile<tbl>)# index 1 operation-type allow
(config-dev<config>-security-mac-profile<tbl>)# index 1 name default
Show command for Profile Table Configuration
Device-Name# show configure security mac-acl profiletable
// RUNNING-CONFIGURATION //
// MAC ACL Profile Table //
index 1 {
name: Default
operation-type: deny
status: active
}
Address Table Configuration
Perform the following to create a Address table in MAC ACL.
(config)# dev-configure
(config-dev<config>)# security
(config-dev<config>-security-mac)# address-tbl
(config-dev<config>-security-mac-addr<tbl>)#index 1 second 0 status 4
(config-dev<config>-security-mac-addr<tbl>)#index 1 second 0 mac-address 00:11:22:33:44:55
(config-dev<config>-security-mac-addr<tbl>)#index 1 second 0 comment firstrow
Show command for Address Table Configuration
Device-Name# show configure security mac-acl address-table
// RUNNING-CONFIGURATION //
// MAC ACL Address Table //
index 1 {
mac-address:00:11:22:33:44:55
comment: firstrow
status: active
AP-8000 User Guide
121