Proxim ORiNOCO AP-8000 User Manual page 61

Using Web Interface to Manage the Access Point
Configuring the Device
Figure 6-6 Wireless Properties Page
• Status: Check the Status checkbox to enable the wireless interface properties.
• Operational Mode: Select the Operational Mode. This field indicates the operational mode of the unit.
NOTE: If the Access Point's model number ends with -JP, then you can configure the Radio1 only in 11a\11na and
Radio2 can be configured for 11b\g\ng.
NOTE: Russia does not support the following:
— 11n modes
— 40 MHz
• Current Bandwidth: Select the channel bandwidth. By default it is set to 40 MHz.
• Auto Channel selection: Enable or disable the auto channel selection for wireless interface.
• Current Operating Channel: If auto channel selection option is enabled, then this field will show the current
operating channel of the device and also lists out the other channels that are available.
NOTE: Proxim recommends professional installation and configuration of channels.
• Auto Rate Selection: Enable or disable the auto rate selection. If you set it to enable, then it will automatically select
the rate at which the wireless interface will transmit.
• RTS Threshold: RTS Value Range is 1 to 2346. By default, 2346 is set to disable RTS. If set to less than 2346, RTS
is enabled.
• Beacon Interval: By default the value is set to 100ms. You can modify this value.
NOTE: If you increase the beacon interval value, then this will reduce the number of beacons transmitted. Due to this
the roaming and the associated clients may experience a delay in rate of beacons transmitted. Whereas if you
decrease the beacon interval value, then this will increase the rate of beacons transmitted.
• TPC: By default, the unit lets you transmit at the maximum output power for the country or regulatory domain and
frequency selected.
• Cell Size: Select the Cell Size.
• DTIM: Set the DTIM value.
AP-8000 User Guide
61